Analysis of information sources in references of the Wikipedia article "Ribut api" in Malay language version.
|deadurl= ignored (bantuan)|accessdate= (bantuan)(Inggeris)The Survey has estimated that the damage and casualties caused at Hiroshima by the one atomic bomb dropped from a single plane would have required 220 B-29s carrying 1,200 tons of incendiary bombs, 400 tons of high-explosive bombs, and 500 tons of anti-personnel fragmentation bombs, if conventional weapons, rather than an atomic bomb, had been used. One hundred and twenty-five B-29s carrying 1,200 tons of bombs (Page 25 ) would have been required to approximate the damage and casualties at Nagasaki. This estimate pre-supposed bombing under conditions similar to those existing when the atomic bombs were dropped and bombing accuracy equal to the average attained by the Twentieth Air Force during the last 3 months of the war
(Inggeris)The Survey has estimated that the damage and casualties caused at Hiroshima by the one atomic bomb dropped from a single plane would have required 220 B-29s carrying 1,200 tons of incendiary bombs, 400 tons of high-explosive bombs, and 500 tons of anti-personnel fragmentation bombs, if conventional weapons, rather than an atomic bomb, had been used. One hundred and twenty-five B-29s carrying 1,200 tons of bombs (Page 25 ) would have been required to approximate the damage and casualties at Nagasaki. This estimate pre-supposed bombing under conditions similar to those existing when the atomic bombs were dropped and bombing accuracy equal to the average attained by the Twentieth Air Force during the last 3 months of the war
(Inggeris)The Survey has estimated that the damage and casualties caused at Hiroshima by the one atomic bomb dropped from a single plane would have required 220 B-29s carrying 1,200 tons of incendiary bombs, 400 tons of high-explosive bombs, and 500 tons of anti-personnel fragmentation bombs, if conventional weapons, rather than an atomic bomb, had been used. One hundred and twenty-five B-29s carrying 1,200 tons of bombs (Page 25 ) would have been required to approximate the damage and casualties at Nagasaki. This estimate pre-supposed bombing under conditions similar to those existing when the atomic bombs were dropped and bombing accuracy equal to the average attained by the Twentieth Air Force during the last 3 months of the war
|coauthors= ignored (|author= suggested) (bantuan)A fire storm is characterized by strong to gale force winds blowing toward the fire everywhere around the fire perimeter and results from the rising column of hot gases over an intense, mass fire drawing in the cool air from the periphery. These winds blow the fire brands into the burning area and tend to cool the unignited fuel outside so that ignition by radiated heat is more difficult, thus limiting fire spread.
|chapterurl= ignored (bantuan)|chapterurl= ignored (bantuan)|chapterurl= ignored (bantuan)|chapterurl= ignored (bantuan)|deadurl= ignored (bantuan)|deadurl= ignored (bantuan)CS1 maint: archived copy as title (link)|deadurl= ignored (bantuan)CS1 maint: archived copy as title (link)|deadurl= ignored (bantuan)(Inggeris)The mean fire load density in buildings, from the most accurate weighing method, was found to be 530 MJ/m^2. The fire load density of a building can be directly converted into building fuel load density as outlined in the document with Wood having a specific energy of ~18 MJ/kg. Thus 530/18 = 29 kg/m^2 of building fuel loading. This, again, is below the necessary 40kg/m^2 needed for a firestorm, even before the open spaces between buildings are included/before the corrective builtupness factor is applied and the all-important fire area fuel loading is found
(Inggeris) The .90 fractile of buildings in Switzerland (that is 90% of buildings surveyed fall under the stated fire loading figure) had 'fuel loadings below the crucial 8 lb/sqft or 40 kg/m^2 density'. The .90 fractile is found by multiplying the mean value found by 1.65. Keep in mind, none of these figures even take the builtupness factor into consideration, thus the all-important fire area fuel loading is not presented, that is, the area including the open spaces between buildings. Unless otherwise stated within the publications, the data presented is individual building fuel loadings and not the essential fire area fuel loadings. As a point of example, a city with buildings of a mean fuel loading of 40kg/m^2 but with a builtupness factor of 70%, with the rest of the city area covered by pavements, etc., would have a fire area fuel loading of 0.7*40kg/m^2 present, or 28 kg/m^2 of fuel loading in the fire area. As the fuel load density publications generally do not specify the builtupness factor of the metropolis where the buildings were surveyed, one can safely assume that the fire area fuel loading would be some factor less if builtupness was taken into account
Pekan ini adalah di tengah-tengah puting beliung api. Api itu datang dari semua arah pada satu masa, dan angin telah menderu pada 100 batu sejam.
|deadurl= ignored (bantuan)|deadurl= ignored (bantuan)|deadurl= ignored (bantuan)CS1 maint: archived copy as title (link)|deadurl= ignored (bantuan)CS1 maint: archived copy as title (link)|accessdate= (bantuan)|chapterurl= ignored (bantuan)|chapterurl= ignored (bantuan)|deadurl= ignored (bantuan)|deadurl= ignored (bantuan)|deadurl= ignored (bantuan)CS1 maint: archived copy as title (link)|coauthors= ignored (|author= suggested) (bantuan)|deadurl= ignored (bantuan)CS1 maint: archived copy as title (link)|chapterurl= ignored (bantuan)|chapterurl= ignored (bantuan)